Serving the Northern New Jersey Area
Top Rated Local Company

The Best Way to Paste Background at the corners: instructions, gluing outer, inner Part, docking

The Best Way to Paste Background at the corners: instructions, gluing outer, inner Part, docking

Step by step instructions for gluing inner corners

When finishing, the major problem can be uneven walls and the consequent folds on the background. It is also essential to take into account that if the walls are twisted , the joints of background canvases might invisibly.

After gluing the last one in the front of the inner corner of the fabric should measure the remaining space. It is measured from the edge of the glued cloth to the adjacent wall, the resulting amount is inserted 10-15 millimeters. When the walls are very curved, then the additional figure may be more.

Cut a strip equivalent to the resulting figure, taking into account the allowance. The surfaces have been treated with glue. Based on the type of coat it can be exactly the wall or both surfaces.

The strip has been glued individually using the cut side to the wallsocket. The wallpaper should go on the opposite airplane.

If the glued wallpaper is sterile, then you want to make a few tiny cuts perpendicular to the springs.

Level or incline on the adjacent wall is a vertical line. The distance from the corner is equivalent to the diameter of the preceding cut strip, not including additions.

The surfaces have been smeared with adhesive, and the coating is glued into the wall using the flat side towards the marked line. The cut side goes onto the adjacent wall.

The best way to glue the outer corner (outer corner)?

Protruding corner ought to be pasted by analogy with an inner, however there are small differences, which also have to be taken into account when working.

Measured the space remaining in the glued background into the adjacent wall. Add 20-25 millimeters to the figure.

A section is cut away, taking into account the added 20-25 millimeters.

Before gluing, the surfaces have been treated with adhesive.

The even edge has to be glued to the background fixed onto the walls, the own cut “extends” into the adjoining plane. If needed, small cuts are made in the place of visiting the other background, smoothed and pressed to the wall.

Draw a vertical strip on the adjacent wall in a distance of just glued cut strip plus 6-10 millimeters.

After applying the glue, the strip is then put on the wall using its flat side into the marked line, going over the edge of the already glued strip.

The joints are smeared with glue and ironed using a rollercoaster. After that, the top layer is cut along the ruler and the 2 layers are joined together.


Your complete satisfaction with our HVAC services and technicians